-
FREE MEMBER
NO Posting or PM's Allowed
OP rod spring
I have a new op rod spring, is there anything I need to do to it before installing it?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
12-23-2009 11:13 AM
# ADS
Friends and Sponsors
-
Advisory Panel
I would just oil and install. Unless your rifle has some sort of special feature.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Before installing it use a patch on a cleaning rod and clean the inside of spring channel. Then oil the inside of the channel very lightly. Some Rem oil on the spring will make it happy.
-
FREE MEMBER
NO Posting or PM's Allowed
I usually grease my op rod springs. Follows the general rule that if it rotates, oil it; if it slides, grease it.
-
FREE MEMBER
NO Posting or PM's Allowed
Grease the first four inches that slide into the Op-rod. Oiled springs are noisey.