Yep, quality hardened steel.
Use carbide cutting tools otherwise you will not get far.
Printable View
Yep, quality hardened steel.
Use carbide cutting tools otherwise you will not get far.
Trying to beat the deep freeze coming our way and did some welding in the garage.
Cut and welded a piece of key stock to the bottom of the piston post.
This gets milled down to the same height of the existing disconnector reset section and extends the length.
This will positively reset the disconnector and take that task away from the striker block traveling over it. I will clearance slot the striker so there is less interference / drag on it moving forward and aft over the disconnector.
https://i.imgur.com/GcTUNVF.jpg
Milled down and the last thing to do is cut down a roll pin to put in the bolt body to retain the firing pin transfer bar.
Now moving to the butt section and the final part in the conversion to test fire.
All the heavy lifting stuff is about wrapped up.
https://i.imgur.com/BE7tlLY.jpg
https://i.imgur.com/hlzDlvD.jpg
Final stretch : Springs, striker and guide tubes.
I mod the striker base to clear the disconnector and radius the edges of the disconnector to clear the 5/16" slot x. 055" deep in the striker base. On my MKI build my striker was making contact / dragging over the disconnector. That bleads force from the firing cycle and drag on the striker resetting the disconnector.
Spring guide, pusher and separator are pretty straight forward to make.
My Bren spring tube has a little wobble in it spinning it in the lathe so when I drop my parts in I will watch for any drag or binding and mod as needed.
Striker base mod -
https://i.imgur.com/UsXVUjZ.jpg
Disconnector and striker -
https://i.imgur.com/xKLHzc2.jpg
Clearance -
https://i.imgur.com/odgecZM.jpg
https://i.imgur.com/bFjmgOp.jpg
Parts -
https://i.imgur.com/yuuFKKo.jpg
Getting close to test fire -
https://i.imgur.com/Ha9kCxw.jpg
Nice machine work...
Thank you sir.
Do you guys up north have any source of small Bren parts available ?
I have a stripped spare bolt I want to populate without donating an arm and leg.
Most of the places here are out of various Bren parts and its getting worse.
Those are prohibited in every form up here. I DID know a man with some small parts but trying to ship them south could presently send one to the crowbar hotel... What's worse is...he's a hoarder and probably would claim no actual knowledge of this if you were standing in front of him. So I guess...no...
My MKII was built 20 years before I was born........
Crazy that small parts are treated like a complete rifle.
A few UK militaria dealers may have some of the legal to own (in the UK) small parts that go in the small parts tin, in the tool wallet.
Extractor Set for .303 BREN, All Marks
I think importing them into the US might present a problem...?