That's right.
Nope, they just sit flush. Inexperienced people sometimes damage the spring by pinching it while rotating the stock.
Printable View
Thanks to Jim here, the confusion on the detent spring is a non-issue. I still cannot understand what the function for hole the middle of the tab or the material that was inside. Another photo online of the same style "D" buttstock had the same hole with the identical same material inside. I'm not concerned about it at this point as much as just curious.
The buttstock and pistol grip will get painted this week in the red.
Searching for an Edgwater Buffer last week produced one from Amherst Depot and apparently, I snagged the last one they had. They immediately shipped it out and it arrived in the mail already this morning. It looks very good.... except for wear around the edge of the buffer where the bolt carrier made contact. Other than that, it doesn't look bad at all...hoping to be as lucky to find a buffer tube next.
Dick
Yes sir, I was a bit shocked actually and surprised. It was the last one they had, and it shipped free, no tax for $150.00 considerably less than I'd any seen anywhere else - and it showed up two business days later in the mail! Finding the proper buffer/extension tube for it may not be that easy, but it's an adventure and the challenge is the half the fun.
Dick
I had a look at their site and drooled a bit over the .50 Quad gun...
....they definitely have some interesting inventory.
POI>
The hole in the center of the buttstock tab was where they filled the stock with foam during production and the tiny "straw" was part of the process.
An aerosol can of "ANA611 Interior Green "arrived today and is not the example shown online at all. It's more like the Brownells 601 Lime Green they used on their first production 601's... $40.72 a can, sucks out loud.
Ha...but wait there's more!
USPS Tracking indicated delivery today from Brownells for a retro 601 front pivot pin. It arrived at the local Post Office OK - just like it was supposed to, but someone decided that made too much sense. So..... they sent it to some place called Rockdale, TX. Tracking now says maybe Wednesday.
Pressing Onward
Jim, pr anyone familiar with the Edgwater Buffer - how is it disassembled?
Thanks