Printable View
Hello all
I'm a newbie here
I need some help with a 1903 receiver and a barrel I bought
When I hand tighten the barrel receiver the witness marks are about 7/16 inch away
Is this too far Any help would be appreciated
Thanks SkyKid aka Frenchie
---------- Post added at 06:56 PM ---------- Previous post was at 06:55 PM ----------
http://
tighten up and be done..
Thank you Sir
Do you have all of the proper tools? Have you re-barreled anything before this project? If not, ship it off to Chuckindenver. It will be done ASAP and done right. I'm guessing the chamber will be tight or too tight. Chuck can fix that problem, too. Chuck did my M1917 and did it right. Good luck.
Calif-Steve
No and no:wave:
ChuckinDenver
What would it cost to ship it to you and have it done
An estimate is ok
I would like to compare to a local gs
thanks
Just call Chuck. Nice guy to talk to.
unlike your local guy, all i work on is Milsurps,,
your weclome to contact me for my rates,
Thanks ChuckinDenver
Can I use the email addy in your signature
---------- Post added at 04:38 PM ---------- Previous post was at 04:35 PM ----------
Another question
If you do it for me
How would I send the receiver and barrel to you
Do I have to go thru an ffl?
Thanks for your help
you would send it to me, i would send it back,,best bet is to just call the number,, Mon, to Thurs, bus hours..
He's honest and sincere. He took care of my 03a3 with a similar problem. Quick and fair with good communication.