Search:

Type: Posts; User: gunny33; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    3,976

    FN49 recoil springs

    Numrich Arms has them listed.

    Bill
  2. Replies
    4
    Views
    4,699

    Early Rock Island Basket Case

    As far as the barrel goes you could do a chamber cast with "Carrowsafe" from Brownels or have a gunsmith do it for you. IIRC the field test bolt is designed to be used with headspace gages "in the...
  3. I have a buddy who has a FN-49 in 7.62mm. It will...

    I have a buddy who has a FN-49 in 7.62mm. It will not run right. Fires, jams, clear jam, fire and jam. Not sure if they were carried and never fired. Likely seldom fired

    CALIF-STEVE: Has your...
  4. Argintine FN49 with canted gas cylinder/front sight...

    Hi Breaker,
    I sent a LUX 30-06 to Guy a few months ago to verify headspace and repair a trigger guard problem. Havn't fired it yet but the cost was very reasonble and service...
  5. Argintine FN49 with canted gas cylinder/front sight...

    Your right about headspacing the FN49's. It's done at the rear of the bolt not the front, by replacing "Locking Shoulders" in the receiver. Give Guy Snelen a call or email, he's at All American...
  6. Replies
    6
    Views
    5,596

    Safe or Dangerous

    PM sent. Bill from Mass.
  7. Replies
    21
    Views
    34,830

    The research I have done indicates that they may...

    The research I have done indicates that they may have assembled a few but the majority of receivers were stand alone when they left SA Inc. I am preety sure that this one was assembled outside the...
  8. Replies
    29
    Views
    36,653

    Best M1A receiver ?

    Hi General Ike,
    For what it's worth I have several M1A's with Armscorp receivers. One I have been shooting for 5 years with no problems. In todays economy and with som patience...
  9. Replies
    21
    Views
    34,830

    Springfield Armory Inc. M1 Carbine

    I recently acquired an M1 Carbine and the receiver is made by SA Inc., of IL. Does anyone have information about these receivers? The piece has all GI parts and an Italian "FAT" stock.

    Thanks,
    ...
  10. Replies
    19
    Views
    15,384

    Parkerizing and Hydrogen Embrittlement

    Hi Mike,
    The plating house I work for does phosphating for several large weapons mfgs [military included]. We bake the phosphated parts at 215 deg for 8 hours. Bead blasting is ok...
  11. Replies
    10
    Views
    14,610

    Original Blackener for Gas Cylinders

    If the cylinder is stainless steel you can use a "Black oxide" coating [akin to blueing]. It will need to be sandblasted. You should plug the ends but it is no problem if the solution gets in as it...
Results 1 to 11 of 11
The SMLE 1903-1989