-
FREE MEMBER
NO Posting or PM's Allowed
No.4 MK.1 Foresight Base Removal
Good Afternoon,
I'm trying to remove foresight base on my rifle and it seems to want to resist my efforts.If
there are any suggestions to make it easier I would appreciate them.Perhaps someone could
point me towards a FAQ section.
Thank You, Mike
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
02-13-2012 02:34 PM
# ADS
Friends and Sponsors
-
drive out the little tapered pin and use a brass drift to slide the block band foresight forwards, off the barrel. On the other hand, it could well be that the block band has been slightly loose in the past and has been sweated in place on the corresponding lugs. So try a bit of heat before you start getting tooooooo enthusiastic with the brass drift and hammer
-
-