Needed, Tap for No4MkI(T) rifle

Building up a reproduction T for a friend who does re-enacting, and who doesn't want to damage a real T. Will be marked permanently as a reproduction to ward off the less than ethical in the future....

What I need is a tap for the rear hole where the rear tightening/mount screw goes into the receiver sidewall. 1/4 inch BA?? I assume??

Hal,

The thread form is 1/4 BSF (British Standard, Fine) a tap for which shouldn't be to difficult to find.

If you can't find one near you try Tracy Tools at www.tracytools.com they'll definitely have them.

Cheers,
Simon.

Quote:

---

Originally Posted by Hal O'Peridol

Building up a reproduction T for a friend who does re-enacting, and who doesn't want to damage a real T. Will be marked permanently as a reproduction to ward off the less than ethical in the future....

What I need is a tap for the rear hole where the rear tightening/mount screw goes into the receiver sidewall. 1/4 inch BA?? I assume??

---

Thanks Simon!