Does anyone have an old manual that describes how to mount the original scope sidemount that had been made by Griffin and Howe? I'd like to see the directions.
Printable View
Does anyone have an old manual that describes how to mount the original scope sidemount that had been made by Griffin and Howe? I'd like to see the directions.
If you are talking about the lower mount with the screws and pins, only Griffin and Howe mounted those.
They will do so today for $650, iincluding the mounts, but no scope.
Plus, G & H mounted the brackets (lower mount) BEFORE the receivers were heat treated. Then the receiver & bracket were heat treated and parkerized as a single unit.Quote:
Originally Posted by Redleg
Drilling and tapping holes and staking the screw ends AFTER heat treating is a much harder job (no pun intended).
Click on this link and scroll to nearly the bottom of the page to see the G&H webpage on the M1 scope mount
http://www.griffinhowe.com/mountsandpads.cfm
Notice they only seem to be cataloging 1" rings which would not be correct for an M1C.
To answer your original question however Nicolaus Associates Garand, M1, M14, M16, Carbine, 1911, 1917, Militaria, and Small Arms Information has a great selection of manuals including both the standard M1C and the USMC version (MC1952 w/MC1 scope and mount). They are reprints but the quality is the best going and their customer service is excellent.
Regards,
Jim
Thanks Guys,
'preciate the thoughts. I know Griffin & Howe websight and have seen their instruction sheet. I wanted to see what the Military Manuals said in case it adds some clarity to the process. So, special thanks to you J Gaynor, the website you listed had the Ordnance Manual which I bought and read.Their reference to drilling the case hardened receiver with a high speed steel drill isn't one I'll follow. Based on my toolmaker experience I will use carbide drills and I'll also use a nitrided tap for the screw holes.
Thanks again to you all for your suggestions.
Stockerphil