No 1 MkIII Stock repair

Hi all, sorry if I'm a bit off topic, but due to the relevance I hope you'll forgive me.
Quite a few No1 MkIII fore ends dissintegrate just like this and I've done this repair on a few of them.
This one is done except for needing a copper/brass reinforcement wire through the rear. Also I have only part fitted the draws so that I can fit it to the actual rifle when I see the bloke.
The fitting of the little metal tie is a very difficult little fit up, for the next one I'll make an appropriate router jig.
This is always a very time consuming job, and it is not financially worthwhile, but it's nice to keep them going any way.
Attachment 15932 Attachment 15930 Attachment 15933 Attachment 15929 Attachment 15934 Attachment 15931