1959 British enfield no. 1 mk iii drill rifle-display
Guys,
I recently acquired this critter. It was advertised as a "parts rifle" or for display. Mind you, every surface is stamped "DP". So it would take a bit of work to remove these marks, and to fully use them in other rifles... :madsmile:
BRITISH ENFIELD NO. 1 MK III DRILL RIFLE-DISPLAY
So here are some photos of it:
https://www.milsurps.com/images/impo...ufacture-1.jpg
Magazine painted with stripes...
https://www.milsurps.com/images/impo...genfield-1.jpg
DP marked bolt.
https://www.milsurps.com/images/impo...bolthead-1.jpg
Drilled hole in receiver through barrel.... Otherwise the rifle is intact. The barrel isn't welded in... no extra "clip" off the receiver.
https://www.milsurps.com/images/impo...illholes-1.jpg
DP marked nose cap.
https://www.milsurps.com/images/impo...ldEndCap-1.jpg
Handguard repair! Small chunk falling out of it.
https://www.milsurps.com/images/impo...renfield-1.jpg
Rear sight is nice and clean, but has the DP mark.
https://www.milsurps.com/images/impo...Penfield-1.jpg
Here is the receiver side. I can't quite make out who imported (?) this none rifle. I think it says:SPR SP(?) PN RN PA. There are additional markings about 2inches ahead of this... but I can't get a good photo.
https://www.milsurps.com/images/impo...senfield-1.jpg
The stock is stamped with various marks... and the DP stamp!
https://www.milsurps.com/images/impo...dpstamps-1.jpg
Here we have the brass buttplate. Sadly I checked to see if there were any hidden goodies... and its a no-go! :crying:
https://www.milsurps.com/images/impo...eenfield-1.jpg
Thought or comments???:D