L42 Transit Case Corner Piece

Attachment 38347Attachment 38348Attachment 38349

Attachment 38350

When I bought my L42 two of the metal corner pieces on the transit case were missing. I looked at having a batch made as this seemed to be a common problem, but unfortunately the cost made it a non starter so I decided to make a couple myself.
I found a distressed piece of galvanised plate of the correct gauge that was in keeping and used the original corner piece as a pattern to cut and file the two blanks to shape. The edges were folded in a vice with smooth jaws, but the challenge was reproducing the three punched countersunk holes. I turned up a male and female former in the lathe (see picture) and used the spigot on the male former to align it to pilot holes drilled in the corner piece. I then used the vice as a press for the forming tools
I think it worked out rather well - see if you can spot the original among the three in the pictures.
I've attached the sketch I used to make them if anyone else wants to have a go

Why don't you make 20 sets and sell them on...........

Been there, done that!

The one on the right, top pic, and centre bottom of the second pic.

Well spotted - mine obviously not as good as I thought.............

I seem to remember that these corners were just a commercial item. The Equipment repairers used to stock all of these things. But always needed when the chests were thrown about by the cack-handed storemen

Well done. The lack of paint is a clue.
I need a set.....

Actually, it's the corner radius, yours are sharper than the original.:rolleyes:

Try these people, theres a corner piece that looks exactly right.

Comprehensive Range of sort after cabinet, Household, Mobile home & Office fittings. High Quality & low prices with reasonable P&P [S&H} for the whole world.

Have to comment on the link... I see it more and more often, people's incorrect usage... third time in a week I have seen the word "SORT" when it should have been "SOUGHT"