Extractor screw and thru bolt for TZ 47 sight on No4 Mk 1/2

Hello,

I am looking for a good source for the extended extractor screw and the rear bolt that replaces the pln on a No4 Mk1/2. I have a TZ 47 sight that I would like to mount on one of my rifles.

Thanks,

Chris

Chris B,

Might want to give this a try. I ordered some obsolete screws from him a year or two ago.

Services

Hope this helps,

Brian

Also the internatinal auction site - item number 181057138131 - look for quality materials and maufacture in the fasteners - I have come across reproduction screws where the material is brittle and the heads and slots are poorly formed ndwill barely seat or greet a driver. The TZ does not require a lot of torque to live hapily on the No4 receiver - the sight axis pin replacement bolt can deflect the body walls if you get over zealous - the better kits provide a lock nut so you can hold torque and keep the original wall spacing.

I hope this helps!

Quote:

---

Originally Posted by Brian B

Chris B,

Might want to give this a try. I ordered some obsolete screws from him a year or two ago.

Services

Hope this helps,

Brian

---

Thanks!

---------- Post added at 05:42 PM ---------- Previous post was at 05:41 PM ----------

Quote:

---

Originally Posted by l1a1 breakdown

Also the internatinal auction site - item number 181057138131 - look for quality materials and maufacture in the fasteners - I have come across reproduction screws where the material is brittle and the heads and slots are poorly formed ndwill barely seat or greet a driver. The TZ does not require a lot of torque to live hapily on the No4 receiver - the sight axis pin replacement bolt can deflect the body walls if you get over zealous - the better kits provide a lock nut so you can hold torque and keep the original wall spacing.

I hope this helps!

---

Thanks for the info.

Chris

I have a few new genuine sets I got from Parkers before they finally closed the doors PM me if you still need a set.

No4 Mk2 forend cross bolt works well. A bit long so fit a nut or cut it off as you prefer.