Trying to get a data sheet completed. Have a Inland 6 digit serial# 3907** here with square S flip sight base.
Any similar out there?
THx,
Charlie-Painter777
Printable View
Trying to get a data sheet completed. Have a Inland 6 digit serial# 3907** here with square S flip sight base.
Any similar out there?
THx,
Charlie-Painter777
Were some in the 50xxxxx seven digit range
I've got one 6 digit Inland, but it's just got the small "S" on the left side with no other markings. If it's staked, does it look typical for the way Inland did them? - Bob
Bob,
It is staked with the side Chisel type we find on Inlands.
Sure looks like it's been there forever.
Anyone know which CC letter(s) I should check?
Charlie-painter777
Two of the four 6 digit Inlands I have has the standard "s". One has "wsi" and the fourth has a replaced adjustable sight. I do have an Inland in the 3 mil range that has a squared "s".
Charlie, the 2563XX I got from a very trustworthy source (unlike the one we discussed previously) has a small "S" on the left side with no other markings. It's not staked.Quote:
Originally Posted by painter777
Bill
CCNL'S re: Inland information 1st block--#346, 2nd block-- #353, 3rd block-- #361, & 4th block--#372 John
I have an Inland 4 digit all original. sn 1205 ,it has an S with serif on left side. Tom
If this sights been on there that long, I'm sure it'll sit still long enough to post some pics.
Just got a chance to De-Grime and write down parts today.
Will attempt pics in the next day or two.
Thx,
CH-P777