Hello all, how does one remove the carry handle sleeve off the Bren Mk 1 barrel please. Thank you
Printable View
Hello all, how does one remove the carry handle sleeve off the Bren Mk 1 barrel please. Thank you
To get the handle sleeve off the barrel, you first remove the screw holding the handle assembly onto the sleeve, and remove the handle. Then you punch through the uppermost little pin (which is covered by the handle base when it is installed). Note that as you withdraw your pin punch, there is a little cap (by the book name: plug) and spring that are going to fly, usually never to be found again. Be ready for this and have a rag blocking it's exit.
With the spring and cap gone, you hold the handle upside down and the lower plunger will back out enough that you can slip the sleeve off. On an early sleeve, there is a second pin retaining the plunger in the sleeve. In a later sleeve, there is no second pin....the plunger should just fall out once you have the upper pin, cap and spring (and 60 year old grease) out.
The fun will come as you try and re-assemble the plunger, spring and cap. You will know what I mean when you try it.
Wise advice from S.C. there! Firt timers should cover the whole lot with a polythene bag when they re-assemble - to catch the plug when it flies off....... And hammer or file a small chamfer onto the entry side of the pin to ease it in.
Zip yourself inside a body bag, they come in handy for many uses...no chance of losing it then.Quote:
Originally Posted by Peter Laidler