Help ID'ing Artillery Shell

Hi All,

I just picked up a 4" artillery shell from a guy over on CMP. Neither of us know what it is though. The base flange is 5" OD, base of the shell is 4 5/8" OD, mouth is 4" ID, OA case length is 25 11/16", it has two cannalures below the mouth, and weighs right at 10 lbs. The base lettering consists of: "1939", PB, C/32, and the logo which I drew up because it's so small. See pix below.

https://www.milsurps.com/images/impo.../1TXgk5u-1.jpg
https://www.milsurps.com/images/impo.../xsm3VdH-1.jpg
https://www.milsurps.com/images/impo.../QrIkL1U-1.jpg

TIA!

Russ

Isn't much help, but 4" is 101mm/10cm. Everybody and his brother had a gun that size. Field guns as opposed to anti-tank or tank main gun. Tank/SP guns that big came late in the war. Mind you, 4" naval guns were the standard RN anti-aircraft gun from the late 40's. Haida's main guns are 4" multi-purpose guns.
HMCS Haida National Historic Site

The top symbol of your "drawing" sure kooks like a stylized flaming bomb ordnance stamp.

It looks European & 4" = 99.2 mm. Does that ring any bells? Who had 99mm artillery?

The forum needs a better close up pic of the symbol above the C/32 I am in agreance with Boonie Stomper that it appears to be a flaming bomb though I must say I dont think any of them would be so pedantic as to worry about .8 of a millimeter and just go by 100mm or 10cm artillery nomenclature for ease of identification.

A WAG could be that C= Cordite loaded and 32 a lot No.

"...4" = 99.2 mm..." Nope. 101mm. Multiply by .0254.
"...appears to be a flaming bomb..." Isn't the American one.

This is the best I could get. Looks like a capital "P" followed by a smaller capitol "B", perhaps in a different font?

Russ

https://imgur.com/a/rjZjuRk

Artillery Shell - Album on Imgur

If you look closely at 9 o'clock about halfway in towards the primer hole you can just make out the No.5.

Here is the manufacturer code ~ 05 (5) - Spreewerke, Lübben, East Germany,

Or it could be this one discounting the C which I still reckon stands for cordite leaving 32.

32 - Linköpings Tändsticksfabrik, Lidköping, Sweden.

I completely missed that one! Directly across the primer hole from the "bomb" halfway between the hole and rim edge, is the number "35".

https://www.milsurps.com/images/impo.../cgXKSUl-1.jpg

Russ

I get no hits for 35 surmising it may be an inspectors stamp the only other thing is the C/ may stand for these apart from that the symbols would be the defining mark to identifying the case! Good luck
C - Creedmore Cartridge Co., Barberton OH
C - Munitionsfabrik Cassel, Cassel, Germany
C - Pirotecnico Dell'Esercito Capua, Capua, Italy

Could the C/32 refer to the 105mm German SK C/32 gun? Looks like a similar case.