Printable View
Good Morning,
My usually good tack-drive was a bit testy yesterday at the range with mostly good primer strikes followed by a series of shallow strikes. I need some information to get it going again:
1. Length of firing pin/striker
2. Where to get a new or "newer" mainspring if needed
Thanks,
Randy
Don't know if they're better or not...Quote:
Originally Posted by rescuerandy2
Schmidt Rubin Parts | CO Guns Sales
Schmidt Rubin 1911 Firing Pin Spring – 7.5x55 Swiss | Colorado Gun Sales
What ammo are you using? Are you absolutely certain the bolt is FULLY closing? The back of the bolt handle will go under flush with the back of the receiver, or you will get the exact symptoms you describe. I can strip my 1889 bolt and measure it, but I don't want to do that unless we know we really need to know.
Mine comes in at 4.937" if that helps.Quote:
Originally Posted by rescuerandy2
Thanks. I am 4.941". I have done a very thorough cleaning and will give it another try in two weeks. There has also been a suggestion that I make sure the bolt is closed all the way.
Thanks,
Randy
I am using PPU ammunition with a 20% powder reduction.
Randy
Good. Just a bit of debris in the firing pin channel could stop the pin from full travel. Sounds like the pin has plenty of length. Mine is a bit shorter, but has been completely reliable.Quote:
Originally Posted by rescuerandy2