Anyone got info on reloading 10.4x47R without having to invest in the pricy special order dies ? Is it possible to use other more common dies ?
Printable View
Anyone got info on reloading 10.4x47R without having to invest in the pricy special order dies ? Is it possible to use other more common dies ?
I used .348 Winchester brass cut off at the shoulder and made a black powder blank, wax plug contained it. Then used a .44 bullet on top and they shot fine out to 200Yd. So they were two part ammo but no special requirements...
That would be an expensive work around today Jim. The few boutique ammo manufacturers that still load .348 Win. are charging upwards of $6.00/round.
I suppose but the illustration is to look at a cartridge for base and that was how I managed. There have to be others...Quote:
Originally Posted by Sapper740
Here's a thread about it, I'm not so far off either. I also found a die set for $188USD, others are near as much as $488USD.
Reloading for 10.4x47R Italian Vetterli | Gunboards Forums
10.35x47r ITALIAN VETTERLI: Cheap and easy.