Of course, that's exactly what's happening because that's what it's for. If it's not heated then it won't come out, I'm sure he said he's done that...Quote:
Originally Posted by RobD
Printable View
Of course, that's exactly what's happening because that's what it's for. If it's not heated then it won't come out, I'm sure he said he's done that...Quote:
Originally Posted by RobD
To no end...Quote:
Originally Posted by browningautorifle
Carbide end mill and tap are enroute!
Once you've centred up your mill over that stud hole, John, I'd probably put a small drill through first before going through with your carbide end mill. Otherwise we may have a broken cutter/damaged thread scenario.
You bet, thanks!Quote:
Originally Posted by Flying10uk
We didn't seem to encounter any of this when we were doing them and the L42 was notorious for shearing off the screws AND the spigot on the front pad!
Quote:
Originally Posted by Peter Laidler
It's pretty bizarre considering 2 came out very easily, the 3rd was a bit tougher, but not bad, and their threads are nice and clean, no rust etc...
You say the third WAS a little harder?
Do you get it out?
Jsne
Yes the third was a little harder to get out, but I got it out nice and clean.Quote:
Originally Posted by jsne
Should now be able to start the re building phase now will start looking forward to seeing the end product
Getting closer!Quote:
Originally Posted by CINDERS
The tap and end mill have arrived, just need the time.