RIFLES looking for Misc Parts

Looking for a bolt stop assembly for my '09 Argentine Carbine. These are the ones that wrap over the rear receiver to support thr stripper clip slots.

I am looking for SIX things, listed in decreasing order of rarity:

1. I need a top wood for a Ross M1905 Mk II** target rifle. The rifle is one of the ones with a barrel mounted sight, so the topwood is a two piece. I'm missing the short one which sits just in front of the receiver, behind the rearsight--the spring retained one.

2. A safety for a Mauser DSM34.

3. A cleaning rod for a long Belgian M1889 Mauser

4. A rearsight for a long Belgian M1889 Mauser

5. A complete set of hen's teeth.

Let me know what you have.

Thanks.

Ed

Looking fo a bayonet lug and heat shield for a Stevens 530-20 trench gun.

I am looking for a 7.62 magazine for my Enfield Enforcer #395. Somewhere out there must be the correct magazine stamped on the bottom with 395. Anyone have this, or know of its whereabouts?

I do know of the whereabouts of the magazine for Enforcer #392, if anyone has that rifle.

Need "beech" rear handguard for my M1 Garand.:)

Looking for the following REMINGTON parts, marked with an "R". I'm not having very good luck with the internet parts companies. Any help would be appreciated. Wouldn't mind a reasonably priced "lot" for everything. :wave:

- Front Barrel Band
- Bolt Stop
- Bolt Sleeve
- Cocking Piece
- Sear
- Rear Swivel Base and Swivel
- Trigger Guard

Thanks!

I've plastered requests all over the place, but one more place won't hurt :)

I recently bought a Long Branch No.4 Mk.1 that is sorely in need of attention. To this end, I am looking for a replacement early Long Branch forend (the one with the low right hand wall that was for the cut-off that was never fitted), and a Mk.1 micrometer rear sight stamped with the Long Branch stamp (L overlying a B). Thanks.

Looking for a period correct stock with hardware for a 8mm mauser m1924 type 2.

I need the fore end wood, (top and bottom) and the nose cap for a Lee Enfield Cavalry Carbine Mark 1.

I have a lovely DSM 34 which is missing its safety. The remainder of the bolt is intact. I would buy a whole bolt if necessary, or if someone has a crap DSM 34 I could buy the rifle for the safety. Mine is a nice custom deluxe one with fancy dark walnut stock, etc.

Thx

Boltaction