Dean's Gun Restoration.....How can I repair his Restored M1?

IN 2001, I bought a M1 from Dean. In 2001, I fired it once and the gun jammed. For a variety of reasons, I did not pick up the rifle until recently to see what is wrong. I compared my M1 to another and saw that the bolt is not going fully forward and thus the stud on the bolt is not going into its notch on the receiver. There is a burr on this end of the barrel and I believe this burr is preventing the bolt from traveling fully forward. I don't believe firing one round would have caused this burr.

I am retired and on Social Security and do not have much discretionary income. I have contacted Dean and asked him to repair the rifle at no cost to me and his position is the M1 is beyond his 1 year warranty.

Can someone tell me how to repair the rifle or if necessary does one know a reasonable M1 gunsmith in the Huntsville AL area?

This is common with M1's and M14/M1a's some rifles do it while others do not, the bolt is kissing the top of the barrels hood after a few rounds the two will wear in together, grease your m1 up and hit the range after a few clips she should feel slick and smooth.

It appears to me that your oprod has dismounted. Put it back in the track and see though it may be worn to the point of needing repair. George

Looks like the o.r. has jumped out of the receiver track. that would keep the action from closing completely.

Op Rod not in track. Re-assemble and see if it stays in the track. If worn beyond serviceable replace the OP rod.

Attachment 28141

Are you using ammunition correct for a M1 Garand ?

Aside from a fairly coarse bead/sand blast before finishing, the parts enlarged here don't look hideous. Possible that the op rod was pulled from it's track when the bolt was being eased forward?

https://www.milsurps.com/images/impo...st200911-1.jpg

Thanks to everyone

The important thing here Jon is it's likely something simple. Strip, clean and assemble carefuly and try it out with some reliable ammo of current manufacture. Do like these guys said and grease the parts and give it a chance. If it still doesn't work, get back to us.

BTW, I'm using M2 Ball bought thru CMP

OK, That's good. Just try the strip clean and grease before assembling and see what happens.

Having a second man on hand that's used to these guns might help. You'd be surprised what a witness can pick up. Some small thing that matters?

While you're at it, make sure the gas screw is tight, it only takes a few seconds.
Charlie

pm sent as to your question.

Bubba

Mr. Admin,

I beg to differ with you. This thread clearly starts out as saying Deans screwed me. It is not stating the fact that a 10 year old build has a problem that is not Deans fault by any stretch. The title and the statement on how Deans refused help shows me the original poster is blaming Dean but in reality it is the owners fault as this clearly happened while in storage and something was dropped on it. No way did he take this rifle and just put it away. If he did shame on him but not Dean.

Personally I do not like how this thread has been making its way all around trying to put blame on Dean for someone else mistake. Rick B

Agree. This is the second post from low # posters airing dirt. It'd be different if poster had 250+ posts, but these smell fishy to me. 10 year warranty? Please.......

The original poster has asked his question and got his answer, there is no point in debating the intent as this will go nowhere.