Printable View
I'm looking for a couple of screws for the scope rings on an #32 Enfield sniper scope. Wondering whether there is a source for these screws, which are a unique shape. They appear to be approximately M3.5 and are about 17 mm long. Here is a photo of one:
https://www.milsurps.com/images/impo...ew_004XL-1.jpg
Thanks for any help!
You might try and contact Scott Stonehill at Evans Custom Screws. I bought four cradle screws some time back, and they were perfect.
Here is a link to his website:
http://www.customscrewsandmore.com/P...dServices.html
I addition to the cradle screws for the No4(T), I also purchased a set for a long-lee and I couldn't be happier.
Best of luck
If you don't have any luck with smleaddict's lead, you could try Fultons of Bisley here in the UK. They used to sell sets of faithful reproductions. Not sure if they still have them, but worth an ask. The screws are threaded 4BA, by the way.
Thanks so much for the replies. I've contacted Evans Custom Screws and if that doesn't pan out I will try Fultons.
They are of the type known as filister head.
Filister head........... Mmmmmmm, not according to the engineering bent stuck deep in my memory banks and a reminder from my (old Uni so a bit out of date ready-reckoner) Machineries Handbook. They were always referred to as taperlock head. Old fashioned even before the war and superseded by other things - such as torque wrenches! It was impossible to tighten up these screws once a certain torque/load figure had been reached as the taper would lock-up solid. Good to prevent crushing tubes etc. All a bit academic but I seem to think that they were a morse taper - same as locked up your lathe chucks etc
Enfield has used taper lock head screws since the P53 in the Baddeley style barrel bands. They can be a bas*tard to get out if they are in tight.
I contacted Scott at Evans Custom Screws, and he said he did make these screws. I'm having him make up a batch for me. I'll post up some photos once I get them. Really appreciate all the replies. Special thanks to smle addict for the lead to Evans Custom Screws. I don't know how we would every maintain these older firearms without guys sharing their knowledge.
Just for the forum Peter and you have probably answered this question 3 zillion times before but I am keen to learn new stuff but as they were a tapered body and you say they were designed to lock up at a certain torque @ what torque should be applied to those screws in mounting the No.32 scope to the bracket.
I wish ring manufacturers would use these to stop people crushing scope tubes by making sure the scope will not move by putting Gorilla arms into those tiny screws.....? TIA
I will hazard a guess that Peter will reply 'Do them up less than a gnat's nadgers tight' or something similar!
Gnat's knacker is a measure of length, weight, volume or mass.
There was an attempt to have the standard defined by the British National Metrology Institute. But the motion was defeated due to heated debate, yet no determination as to which is the actually the smallest quantum, gnat's knacker or coontair.
Hi, I have what you need, selling @ $3 each including shipping. If interested pm me.
Got the repro screws from Scott at Evans Custom Screws. Here are some photos of the new screws on the left in the photo next to an original screw on the right. They work well. If anyone else in the US needs these screws then you can contact Scott: sstonehill@knology.net
https://www.milsurps.com/images/impo...1B_003XL-1.jpg
https://www.milsurps.com/images/impo...20CopyXL-1.jpg
I think this contact may prove very useful to forum members.....