Printable View
Took my SMLE apart for a clean since it has been a few years,
The condition of the drawers hasn't changed but ive always thought they looked a bit average,
Are these acceptable for use?
Attachment 110060Attachment 110061Attachment 110062Attachment 110063
You do realise there is a difference between drawers, and the draws on a LE?
Nope, but i do now.
Looks like a crack in the left hand draw - or am I mistaken? If I'm right, I would suggest drip superglue into the crack in an attempt to buy time before a big repair is needed.
While you have it apart glue and pin the crack and fit some copper plates save a bigger job down the track
---------- Post added at 07:23 AM ---------- Previous post was at 07:22 AM ----------
Get the oil out of there before any glue goes inQuote:
Originally Posted by pisco
Thanks Pisco, any idea on a source for the copper plates?
Quote:
Originally Posted by pisco
Send me your mailing address and I will send you a set
Thanks heaps mate, i really appreciate it. Message inbound
Brush the whole forend down with linseed oil inside and out and let sit for a few hours then wipe off. Repeat for as many times as it will continue to absorb the stuff.
Shrinkage due to drying out is the major reason for forend problems, IMHO.
Though your's doesn't look that dry in the photos. Glue the crack first too of course!
Parcel sent today
Thanks again mate!Quote:
Originally Posted by pisco
This article may help with the repairs.
https://www.milsurps.com/content.php...ter-Laidler%29
Thank you Dan, very helpful and explained clearly