Originally Posted by
Bruce_in_Oz
BAR:
Calfed:
As a general point, the decapping spindles can often be fettled back into shape. Pins? Not so much. Check out the Lee decapping system; the "spindle" is not threaded, but smooth and is retained by a top nut assembly that is essentially a "collet". If you try to deprime a Berdan case, the pin is simply forced back up in the collet and not mangled. (Works on all but the most insanely-crimped boxer cases).
And check out Lyman's .22 and .30 cal Tungsten Carbide decapper / expander ball kits; they come with a couple of adapter plugs so they can be used in a wide variety of dies. These seriously reduce "drag' as the ball exits the case neck. Less drag: less stretch and less noise.
On a different tack: I destroyed both a CH and an RCBS primer-pocket decrimper tool, prepping "surplus" brass. Then I coughed up for Mr. Dillon's masterpiece and have never looked back. Only thing I did was to run a small, Tungsten-Carbide centre drill bit into the end of the "large" pocket swager, so that I could do the pockets of the very same Berdan cases that mangle the decapping pins of the unwary.
