Printable View
The bolt latch on my M1917 is very difficult to open to remove the bolt. I have to use a padded screwdriver to pry it open in order to remove the bolt. The bolt stop and ejector work fine. I put in a new flat spring and rest but this did not help. Any suggestions?
Is it rubbing on the stock?
Is the screw pin bent. I have replaced alot of them due to being slightly bent.
is it frozen with dried 1910's+ grease? That stuff can act like glue when it is mixed with dust and ages for 100 years.
Thanks for all the advice. I will check each one out. I know it's not a grease problem as I have degreased and oiled it. Don't think the screw pin is bent but will check that out. I bet it is rubbing against the stock. Thanks again.
Look for pressure making it drag against the stock on bottom edge.
They have always been much more difficult than a 98 Muaser.
Agreed. I have needed to use a tool on a couple to get the bolt release lever to move.Quote:
Originally Posted by m1903rifle