Quote:
Example hand guard made for U.S. Krag Jorgenson Carbine. Wood Only NO METAL. Semi inlet and will require fit and finish. Rivet holes are not drilled. Wiped down with mineral spirits and is not finished.
All semi-inlet products require final fitting to your action and final sanding and finish of exterior of stock. Semi-inlet products do require some knowledge of firearms and woodworking skills for installation.
Progress update...with the vertical surfaces in the main area done, I've been working on balancing. I finally have uniform contact on the receiver flat, but the rear of the tang is low to where, when screws are in, the barrel was up by 1/4" inch or so ( I think I said that already) I lowered the flat with a 1+1/4 chisel to maintain uniform contact, until contact at the receiver ring was made. The barrel is only off the muzzle by 1/8 inch now. Doing a bit of trigonometry, that requires the contact at the receiver ring to be reduced by .027 or so.