Search:

118948Here is a 3006 and 7.7 after firing and a unfired 7.7

I've been busy with other things but I'll give an update on this rifle. A 3006 will chamber but after firing it wont extract because I think the rim being a tiny bit smaller the exacter doesn't grab...

The case got much longer and has the sharp shoulder and when I measured it it has the same dimensions as the ackely. No marking any where as to getting re chambered. The stock has been cut short on...

I got a type 99 and when I fired it my 7.7 brass turned into a 3006 Ackley. I do have a very good extra barrel but was wondering if I should try and work up loads for it but using the 312 bullets. It...

Thanks for replies.
I will try single load method and keep with the lighter bullet around 150gn. Now I have read to take an empty case and put the bullet in slightly and close the bolt so bullet is...

Just getting started reloading for my 1903. I have Imr 4064 and 150gn flat based spire point factory seconds. Any tips or experience to share. Should I keep to listed OAL. I have a redfield peep...