Search:

Or so close as to be irrelevant. 7.5 mm accurately converts to .2952

That is Lands Side not the grove size of course.

I have had that happen a time or two. You check them and ok and you think they stay ok.

Then you think, its never been this bad and you find the screws loose on the gun, scope, mount and ...

Got the 1911 down to the range. Cases were too big so I had to resize some.

I wanted to see what kind of sight picture I got not target.

It was amazingly good. Been so long since I shot...

If the loads are good (yep, case prep) and I am on, I can shoot under 1/2 MOA. I figure that is not too bad for someone who started target shooting at 60 or so.

If I can retire I might try...

Pierre: I had read that on the other site and I did make sure the clamps were loose. Still got erratic groups.

Like you, the mantra is not to do anything to the gun that affects its...

1000 of the H 168 ELD on the way as we speak (write)

AK prices are really high. Far lower cost to order and flat rate them.

I did metal shim up both ends of the K-31. The front has a...

I lust after the Co-axe, sigh. I have to perfectly good Rock Chuckers (one was a hand off from a brother who no longer reloads)

I have not figured out a way to get them setup at the same time...

I am working up with R17 as we speak. Been using it for a while, somewhat lower price and what was available and Hornady acualy listed it for 30-06 loads.

That is some incredible drawing. ...

Some great information that could be lost and cut and paste into a document the history section so I have it and can pass it on.

Clearly the Swiss came out with a heck of a cardie in the GP11...

Thank you on the Berger VLD, I will look into those. Did not know. Really fortunate being in AK the guy sent me the GP11.

Pierre: I am one of those Americanized people of German decent...

Now that is some carving and take all the time you need.

Once I looked into the 7.5 I got more and more impressed.

Pulling and examining the GP11 bullet and nothing remotely like it I know...

I have followed your postings on the Swiss site, you have presented a lot of good and very good information and I respect that.

I look forward to a discussion over all of the posting done above....