Search:

Type: Posts; User: sundawg3; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Search: Search took 0.01 seconds.

  1. Thread: 1903 Mark 1

    by sundawg3
    Replies
    9
    Views
    2,602

    Understood. This one has the two outer holes with...

    Understood. This one has the two outer holes with threads and the two inner holes without, assuming for dowl pins. This leads me to believe it was a mount similar to Paul Jaeger or Weaver but the...
  2. Thread: 1903 Mark 1

    by sundawg3
    Replies
    9
    Views
    2,602

    Weaver, Paul Jaeger, and others I've seen are...

    Weaver, Paul Jaeger, and others I've seen are less than 3 inches total. The hole spacing is 3 1/8 with overall 3 3/8.
  3. Thread: 1903 Mark 1

    by sundawg3
    Replies
    9
    Views
    2,602

    I've been trying to figure what mount was...

    I've been trying to figure what mount was installed on this receiver for some time and can't figure it out. Could the armory have installed a mount or is this a hack job by a civilian?
  4. Thread: 1903 Mark 1

    by sundawg3
    Replies
    9
    Views
    2,602

    Thanks. I did strip the bolt and it closes fairly...

    Thanks. I did strip the bolt and it closes fairly easy with the go gauge, but the gauge does not fall out as I've seen in videos. I have to run a wooden dowl down the barrel and tap it out with a...
  5. Thread: 1903 Mark 1

    by sundawg3
    Replies
    9
    Views
    2,602

    1903 Mark 1

    New to this forum. Lots of good information here. Thanks.
    I purchased a Mark 1 for my son for his birthday in February and have been obsessed with it since. Defiantly my favorite gun ever and it's...
Results 1 to 5 of 5
BDL Ltd.