How about the Rudy Furnace front sight sold as a Rockola front sight?
Type: Posts; User: lbelflowers; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)
How about the Rudy Furnace front sight sold as a Rockola front sight?
I think it is an E169 by Carbine Club standards. Depending on the cam cut and a better picture of the arm joint area.
Its a Kal Machine Works hammer for Inland, sent to Rockola. The R overstamping the I, Kal Machine Works was Rockola`s only hammer subcontractor until around Febuary 1944.
I would start out with 2400,initial 12 grains,load about 10-15 and run it through your chronograph. Never used the Ranier bullet but, I am sure someone has. You can always ask on the CMP reloading...
Just reading about it on another forum this week. People here in the states are going nuts over anything firearm related, gunshows are having lines out the door! Just pull any state on Armlist and...
Good luck at Walmart! I think they put a 2 box limit nationwide(on any ammunition).
.U. on the left wrist of the stock meant it went through an Underwood rebuild between WW2 and the Korean War. Standard Products also had a contract to rebuild carbines after the war. Most likely when...
Most were done during an arsenal rebuild.
I am going to play the dumb one here, are you using spring pressure from the slide to ream the headspace?
Charlie,
Were you able to get more information from your friend? Email me if you can:
lbelflowers@live.com
The worst of all this is, a new person will buy this out of emotion and later find out they have been duped! Doing homework,researching for yourself will surely save someone from disappointment.
It could be a replacement or could be original. The complete serial number is needed. 5th interchangeability in War Baby in the 4.7 million range used Winchester and Inland barrels. The proof p for a...
Many people try and mislead people point to reference books as having all the answers. Many times the writers of these books lift information from someone else and continue spreading bad information....
Here goes the can of worms! Depends on which side of the fence you are on. Folks value the CMP carbines like they are gold and import marked carbines like crap.
Loren
Probably talking about the Auto Ordnance carbine, think they msrp around $800.00 though.
Why do people buy junk like this?
ChipS, PM me please.
Meant to say LT-R hammers(contract awarded) instead of LT-Q hammers. Just read over what I posted last night. I am sure that BQ97 or Newscotlander are better versed in the Rockola hammer area.
Those are Kal Machine Work hammers and that was Rockola`s original hammer supplier. Here comes the part that I might get tripped up on. When the Carbine Committee handed down the termination...
CC newsletter 372. The hammer in question is a Bruner-Ritter T-3 hammer,replacement hammer made under a Springfield Armory contract. For so many years people have thought that a part with a prime...
And the LT-Q has a good chance of having a R stamped on it. Read CC #372,thanks Brian for the write up!
What`s this matching numbers thing?
You need a LT-R hammer.
I know this is very late to the party. I like War Baby and CC newsletters however,this is on Amazon.com:
War Baby! The U.S. Caliber .30 Carbine, Vol. 1: Larry L. Ruth: 9780889351172: Amazon.com:...
I am thinking a 12/43 barrel.