Search:

Type: Posts; User: Matt85; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Search: Search took 0.03 seconds.

  1. Replies
    1
    Views
    629

    Load data using PPU .268" 139gr FMJ?

    I finally scored a couple bags of PPU's .268" 139gr bullets off of Grafs but haven't had much luck finding data. Anyone have some 6.5x52 load data using these bullets?

    thanks!
    -matt
  2. I tried IMR 4064 and RL-15 with no luck, they...

    I tried IMR 4064 and RL-15 with no luck, they produced very erratic velocities. I have some Varget and W760 but I'm having trouble with my sizing die so the project is briefly on hold.

    If anyone...
  3. There are very few markings on this rifle....

    There are very few markings on this rifle. Without taking it apart, the serial number and some proof marks are all thats visible.

    I wish I had a source of proper diameter bullets, but for now Im...
  4. Replies
    2
    Views
    654

    Thank you, I will give them a call. -matt

    Thank you, I will give them a call.

    -matt
  5. Replies
    2
    Views
    654

    6.5x52 Carcano die set trouble

    I've been having tons of trouble with my Lee die set! First the shell holder is too loose and has been damaging rims. Then the primer punch pulled out inside a case. Now a case is stuck inside the...
  6. 6.5x52 load data using the 160gr Hornady bullet

    Any one have any load data for the 6.5x52 using the 160gr Hornady bullet? I've found very little data for this cartridge!

    Thank you
    -matt
  7. Picked up a little Carcano carbine and playing with surplus ammo

    Hello all, I recently picked up a nice looking Carcano carbine. Based on a bit of research with the serial number the rifle appears to have been made in 1943. When I got the rifle the bayonet latch...
Results 1 to 7 of 7
The SMLE 1903-1989