Search:

Type: Posts; User: Aragorn243; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Page 1 of 5 1 2 3 4

Search: Search took 0.16 seconds.

  1. Replies
    9
    Views
    212

    All my rifles are buried and too difficult to...

    All my rifles are buried and too difficult to access to check. Perhaps you didn't get all the gunk out of it and instead packed it in the bottom. Just a thought. I doubt you broke it cleaning it...
  2. Replies
    9
    Views
    212

    Bolt issues seem to be common with Arisakas but...

    Bolt issues seem to be common with Arisakas but if you've never had the problem, it's hard to tell someone else how to fix it. It usually comes down to the part not being correct for the rifle or...
  3. Replies
    3
    Views
    94

    Soviet M38 Carbine

    Finally knocked one of my top ten off the list last weekend. M38 in a proper stock. Obviously a postwar refurbishment but in great condition. Bore is counterbored as most are. Serial numbers all...
  4. Replies
    9
    Views
    212

    If it worked fine before and isn't now, common...

    If it worked fine before and isn't now, common sense says something wasn't reassembled correctly. I'd try doing that again before anything else.
  5. If you keep them stored in a dark area that is...

    If you keep them stored in a dark area that is more or less temperature controlled and not high humidity you should be fine. Things that are destructive to anything are direct sunlight, excessive...
  6. In all fairness, it isn't a usual marking for...

    In all fairness, it isn't a usual marking for these.
  7. Any Cavalry Horse Equipment Experts? Photos Added

    I picked up probably the oddest addition to my collection today rather unexpectedly. Spotted some old leather straps in a large bin at an antique festival today and grabbed the end of what I thought...
  8. Replies
    8
    Views
    139

    Yes and I was paying $20 for them a few years...

    Yes and I was paying $20 for them a few years ago. When the surplus drys up, the prices go up pretty fast. I'm not saying you can't get one for less but it's tough doing so. ebay currently has one...
  9. Replies
    8
    Views
    139

    $50 is on the low side of the going rate for...

    $50 is on the low side of the going rate for these so you did OK.
  10. Thread: New here

    by Aragorn243
    Replies
    5
    Views
    184

    Depends on what you want to do. They are always...

    Depends on what you want to do. They are always going to be arsenal refinished so you can't undo that. Hex receiver might go better in the pre-war stock but it depends if they had to alter it to...
  11. Replies
    5
    Views
    230

    A - look like mini balls from the US Civil war...

    A - look like mini balls from the US Civil war which would probably make them for the 1853 muskets in use by both countries.
  12. Not having any steel stock, rods, tools etc I...

    Not having any steel stock, rods, tools etc I found a marble that was the right size and shoved it through. I tend to fix things with whatever I have around the house and have been extremely lucky...
  13. The one on the left In A is an Argentine short...

    The one on the left In A is an Argentine short sword, not a bayonet. Agree with twh on the rest.
  14. Replies
    3
    Views
    263

    Should have found this two years ago. Guisan...

    Should have found this two years ago. Guisan could have explained it. I suspect my source material is the same as yours so I got nothing.
  15. Replies
    7
    Views
    268

    I picked up a full box of loaded cartridges. ...

    I picked up a full box of loaded cartridges. Problem is they don't quite fit. I have to shave the bullets down a bit as I believe they are not inserted quite far enough and they are hitting the...
  16. Not a matter of issuing troops unsafe rifles. It...

    Not a matter of issuing troops unsafe rifles. It is a matter of cutting corners, speeding things up and utilizing less resources or other resources because the correct ones are no longer available. ...
  17. Replies
    8
    Views
    325

    I'm with Patrick on this one. No markings and...

    I'm with Patrick on this one. No markings and questionable workmanship.
  18. Replies
    7
    Views
    393

    It's not a gravity knife so no on that regard. ...

    It's not a gravity knife so no on that regard. It is a standard folding blade that is too big to fit in a pocket open or closed so not easily concealed either. I'm sure there are some places it...
  19. Replies
    7
    Views
    393

    I have both the fixed blade and folding blade US...

    I have both the fixed blade and folding blade US versions. Never knew there was a British version.
  20. Replies
    7
    Views
    393

    One more thing to look for.

    One more thing to look for.
  21. Replies
    38
    Views
    1,304

    My step mother hated that show. Said something...

    My step mother hated that show. Said something to the effect that the Nazi's weren't funny, shouldn't be glorified on a show, etc. It was one of my favorites as a kid, I still enjoy it today. She...
  22. Replies
    38
    Views
    1,304

    I got flagged once years ago for attempting to...

    I got flagged once years ago for attempting to sell model aircraft decals which had swastikas on them. Forgot about that until these recent posts. Didn't really get in trouble, they just removed...
  23. Replies
    38
    Views
    1,304

    I assume parts are not an issue because I buy and...

    I assume parts are not an issue because I buy and pay for them with Paypal all the time with no issues.
  24. Replies
    2
    Views
    270

    Local ad spotted for optimistic seller

    Putting my 91/30 up here to see whats out there.

    All matching numbers (with the exception of the bayonet) 91/30 Mosin Nagant. I'm 99% sure the stock was refinished as its a light color and...
  25. Replies
    10
    Views
    591

    My last two purchases from Numrich weren't what I...

    My last two purchases from Numrich weren't what I ordered. Not happy with them but as the parts were cheap, hardly worth the hassle of sending them back.
Results 1 to 25 of 120
Page 1 of 5 1 2 3 4
Service Publications