Search:

Type: Posts; User: Frameman; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Search: Search took 0.01 seconds.

  1. Replies
    0
    Views
    1,650

    Sporterized stock leftovers

    I’m looking for the forward section of a type 99 stock that is leftover from someone sporterizing their stock.
  2. Replies
    13
    Views
    4,456

    Thanks to you all for the advice given. I’ll use...

    Thanks to you all for the advice given. I’ll use the advice and apply it to my rifles.
  3. Replies
    13
    Views
    4,456

    I appreciate your response but I’m asking about...

    I appreciate your response but I’m asking about the torque spec for the action screws through the trigger guard not the barrel to receiver.
    Sorry if I wasn’t clear.
  4. Replies
    13
    Views
    4,456

    Action torque specs

    Does anyone know the torque specs for the type 99 action?
  5. Replies
    5
    Views
    2,477

    Thanks for your thoughts.

    Thanks for your thoughts.
  6. Replies
    5
    Views
    2,477

    I thought this was the case. The only time it...

    I thought this was the case. The only time it might be important could be with a new barrel with 0 throat erosion.
    Thanks for your help
  7. Replies
    5
    Views
    2,477

    Bullet jump on a type 99

    Can anyone answer this question?
    What bullet jump measurement would be acceptable when reloading and seating bullets for the Arisaka type 99 in 7.7?
  8. Replies
    4
    Views
    2,806

    I believe that “headspace”is measured from the...

    I believe that “headspace”is measured from the datum area on the shoulder of the case to the case head by means of the gauges you mentioned. I’m looking for the measurement between the bolt face and...
  9. Replies
    4
    Views
    2,806

    Thanks for the welcome and sorry for the...

    Thanks for the welcome and sorry for the omission.
    7.7 is the info I seek.
  10. Replies
    4
    Views
    2,806

    Case to bolt face gap

    Hello all,
    I’ve looked all over the web for good info regarding the case to bolt face gap measurement and still can’t be sure.
    Is there a definitive source for this info?
Results 1 to 10 of 10
Warpath Vintage