Search:

Type: Posts; User: mtb1098; Excluded Forums: Milsurp Knowledge Libraries (READ ONLY)

Search: Search took 0.01 seconds.

  1. Exploded diagram for a Hensoldt Duralyt 6X scope?

    Does anyone have an exploded diagram of a German Hensoldt 6X scope? I need to repair the reticle and fit it to a rifle with single split rings, and I am not sure about the "removability" of the rear...
  2. Replies
    0
    Views
    2,183

    Exploded diagram for a Dialytan 6x scope?

    Does anyone have an exploded diagram of a German Hen
  3. Replies
    12
    Views
    6,075

    That is exactly what I was looking for! Thank you...

    That is exactly what I was looking for! Thank you both for your help.
  4. Replies
    12
    Views
    6,075

    I was actually just looking at two yesterday on...

    I was actually just looking at two yesterday on eBay. They lack the objective lens bell, and would be more appropriate than the ZF39. But I still cannot judge the scope's length, and the P14T is...
  5. Replies
    12
    Views
    6,075

    The P14 Accumounts are available to support three...

    The P14 Accumounts are available to support three different scope diameters, 22mm, 1 inch and 26.5mm. I think the ZF39 scopes are 26.5mm, but I will confirm that with one of the repro scope vendors...
  6. Replies
    12
    Views
    6,075

    Looking for P1918 Aldis Scope Dimensions

    I am looking into assembling a Pattern 14 Sniper rifle, modeled after the No.3 MkI Enfield rifles mounting the Aldis scopes, and using the Accumount scope mounts. As the Aldis scopes are basically...
  7. Hi, Just bumping this up to see if anyone manged...

    Hi,
    Just bumping this up to see if anyone manged to locate a firing pin in their "stash"? I have sent out some very late PMs, but haven't heard back. If anyone can point me to a correct Firing...
  8. Need help with locating/repairing broken MkII Firing Pin

    Hi,
    Well, I finally found the time to use the bolt disassembly instructions several members were kind enough to attach to my earlier post, and pulled my rifle's bolt apart. Not too difficult, if...
  9. Replies
    3
    Views
    5,769

    Thanks very much. i will give it a try!

    Thanks very much. i will give it a try!
  10. Replies
    3
    Views
    5,769

    Mark II Bolt Disassembly Instructions?

    Hello,
    Trying to disassemble the bolt on my Mark II, and can find only the Mark III disassembly instructions. And frankly, the instructions in the Military reprint are too difficult for me to...
  11. Replies
    5
    Views
    8,001

    Thank your for your input. From a close-up look,...

    Thank your for your input. From a close-up look, the serial number above the manufacture date of 1910 is "294", and I think the first letter after that serial number is "L", followed by an "N". Up...
  12. Replies
    5
    Views
    8,001

    Help Reading Ross Mark II Stock Markings?

    Hi,
    Just looking for some detail on the stock markings of my recently acquired Ross Mark II, sporterized. While I attempt to locate parts, I would like to better understand its history. I see the...
  13. Shots of my stock, for help with identification....

    Shots of my stock, for help with identification.

    60317603166031560314
  14. Hello Mr. Pig, I will send you a PM about the...

    Hello Mr. Pig,
    I will send you a PM about the stock and the band, as I would like both. As for the type of my rifle, I am guessing a 4*, upgraded from a 3* (?) based on what I can read of the stock...
  15. Thanks. I will do that, but I think that I need...

    Thanks. I will do that, but I think that I need to make a more detailed determination of the rifle I have so that I am asking for the right parts, or are the bands on the Mark IIs all the same?
  16. Looking for parts to restore my first Ross, a Mark II

    Hello,
    I just chanced across a sporterized Ross Mark II; found it leaning against the wall in my dealer's shop. He wanted to get rid of it, so it will be coming home with me today. It appears to...
  17. Replies
    8,872
    Views
    2,594,533

    Sticky: New Member wtih interest across the MilSurps spectrum

    Hello,
    I have been a member of the forum for a while, but only today tried to post to a member, so I will do a short bio as required.

    My interests are primarily in WWI and WWII armaments, and I...
  18. Replies
    8,872
    Views
    2,594,533

    Sticky: New Member Intro

    Hi,
    Just joined the forum. Used to frequent the Culver sites. My interests are competitive shooting and arms collecting, mainly WWII era equipment. Garands are my weakness!

    Mike
Results 1 to 18 of 18
Milsurps Talk Radio