-
FREE MEMBER
NO Posting or PM's Allowed
Laminated stocks on K31 s ?
-
01-29-2016 11:32 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Sure it's not an old repair?
-
-
FREE MEMBER
NO Posting or PM's Allowed
No not a repair, a precise job of mating the two pieces with a dogleg exactly in the same place on each side at the magazine opening. The two pieces while close in grain are not a perfect match. This work was done on a high volume planer/router.
-
Contributing Member
My guess is the laminated section is part of the earlier repair. The Swiss did not use laminated stocks.
-
-
Legacy Member
I have a repair on the wrist of my walnut K31 I will see if it matches what you are describing.
- Darren
1 PL West Nova Scotia Regiment 2000-2003
1 BN Princess Patricia's Canadian Light Infantry 2003-2013
-
-
Legacy Member
I have just checked, my rifle had a typical crack repair done in the usual glue and screw method.
- Darren
1 PL West Nova Scotia Regiment 2000-2003
1 BN Princess Patricia's Canadian Light Infantry 2003-2013
-
-
Moderator
(Swiss Rifles Forum)
-
Thank You to diopter For This Useful Post:
-
FREE MEMBER
NO Posting or PM's Allowed
-
FREE MEMBER
NO Posting or PM's Allowed
Back together and refinished !
A gentle refinish (not rubbed out yet) with SK scout scope mount and 2-7 IER scope.
How about those Mineral lines !