-
FREE MEMBER
NO Posting or PM's Allowed
No 4 T parts
Guys,
i am looking for the thread form for the No32 scope windage and elevation screws,
the DIA is 0.187 x 32 threads per inch but 3/16 bsf,2BA will not fit any help please guys or drawing would be great as the originals have been lost from the UK
pattern room and the Royal armory
thanks in advance
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-18-2019 07:48 PM
# ADS
Friends and Sponsors
-
Contributing Member
Could they be 10-32 UNF?
BSF threadform is 55 degree angle, BA is 47.5 degrees, and UNF is 60 degrees, which is probably where the issue is.
Can you get a thread gauge on it to check (accepting that it is probably too small to accurately see what angle it is).
-
-
-
Advisory Panel
Originally Posted by
aussiesuperdad
Guys,
i am looking for the thread form for the No32 scope windage and elevation screws,
the DIA is 0.187 x 32 threads per inch but 3/16 bsf,2BA will not fit any help please guys or drawing would be great as the originals have been lost from the
UK pattern room and the Royal armory
thanks in advance
It is a double start thread. ie) there are 2 threads located 180* apart on the threaded shaft.
-
Thank You to Lee Enfield For This Useful Post:
-
The man's right. I believe it's 3/16" x 16 TPI but as it's a twin start thread it's effectively 32 TPI.
-
-
Advisory Panel
There is a dimensioned drawing in a certain little red book on the No.32 scope IIRC. 
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same. 
-
Thank You to Surpmil For This Useful Post:
Register To Reply
