-
FREE MEMBER
NO Posting or PM's Allowed
Op rod wear against stock ferule
If the op rod is lightly rubbing the front stock ferrule when the stock is removed, is that a sure sign that the op rod is bent or the ferrule is improperly pinned?
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
06-22-2009 04:10 PM
# ADS
Friends and Sponsors
-
Senior Moderator
(Milsurp Forums)
What is the wear pattern on the op-rod showing?
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
-
Contributing Member
Take the barrel receiver assembly and flip over
from the receiver heal area look down the op-rod
If all is well the gas cylinder, op-rod, and middle band will look centered when referenced to the receiver legs
If not it may give you an idea what is out
He is no fool who gives what he cannot keep to gain that which he cannot lose
There are no great men, only great challenges that ordinary men are forced by circumstances to meet.
-
-
FREE MEMBER
NO Posting or PM's Allowed
As long as the "rub" does not impede the free flow of the op rod it is fine. We have to keep in mind the speed and amount of force produced when the op rod moves under recoil. To think it should not touch anything under recoil is wishful thinking in my eyes.
Dean-DGR
Register To Reply
