Needed, Tap for No4MkI(T) rifle

[Hal O'Peridol]

Building up a reproduction T for a friend who does re-enacting, and who doesn't want to damage a real T. Will be marked permanently as a reproduction to ward off the less than ethical in the future....

What I need is a tap for the rear hole where the rear tightening/mount screw goes into the receiver sidewall. 1/4 inch BA?? I assume??

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Simon]

Hal,

The thread form is 1/4 BSF (British Standard, Fine) a tap for which shouldn't be to difficult to find.

If you can't find one near you try Tracy Tools at www.tracytools.com they'll definitely have them.

Cheers,
Simon.

Building up a reproduction T for a friend who does re-enacting, and who doesn't want to damage a real T. Will be marked permanently as a reproduction to ward off the less than ethical in the future....

What I need is a tap for the rear hole where the rear tightening/mount screw goes into the receiver sidewall. 1/4 inch BA?? I assume??

[Hal O'Peridol]

Thanks Simon!