-
FREE MEMBER
NO Posting or PM's Allowed
An M1 refurb from Arlington Armory
I bought one of these (M1
Garrand refurb) back in 1993 before the klinton crime bill went through. I haven't fired it much.
I did have 4 shooters (two of them NRA highpower shooters) shoot the rifle. at 100 yards, the 1st for rounds are right on,
the next for rounds are a foot high.
This is the same result of all 4 shooters.
Any ideas?
Thanks
Bob
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
12-12-2009 02:53 PM
# ADS
Friends and Sponsors
-
Moderator
(M1 Garand/M14/M1A Rifles)
Front handguard could be too tight. As the barrel warms, it expands and moves off. Most people suggest that the handguard be slightly loose.
Bob
"It is said, 'Go not to the elves for counsel for they will say both no and yes.' "
Frodo Baggins to Gildor Inglorion, The Fellowship of the Ring
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Are you sure it's Arlington Armory? or could it be Arlington Ordnance?
there has not been an Armory at Arlington(is why I asked). Have you checked the muzzle wear on a gauge? and checked to see if metal meets/rubs wood anywhere? Arlington Ordnance was an importer and broght back some Korean M1's that had some probs at the muzzle from improper cleaning technique's that caused uneven wear at the muzzle from the cleaning rod rubbing.
Register To Reply
