-
Legacy Member
Clip comes partially out with three to go?
Shooting the Springfield yesterday I had two episodes where a clip pops partially out and gets stuck holding the bolt open with three rounds left - I didn't have a camera so my lousy description will have to do. Now I think this is due to the clips - they are somehow faulty - because out of 10 clips only two did this but I thought that I should check with the forum to make sure there isn't something going on with the rifle. Anybody have this happen before? Thanks!
John
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
05-08-2010 12:03 PM
# ADS
Friends and Sponsors
-
Advisory Panel
Check the clip latch for function and spring tension.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
Yes, sounds like a weak "clip latch" spring.
-
FREE MEMBER
NO Posting or PM's Allowed
Premature clip ejection...
Originally Posted by
Sgt Striker
Yes, sounds like a weak "clip latch" spring.
A weak spring might well be the cause; try 'stretching' the existing spring. If the problem goes away, replace the spring with a new one. (Fulton, at http://www.fulton-armory.com/ has a good one.)
You might want to check the notches on the clips that ejected with three aboard. Sometimes the clips get worn, and the latch doesn't properly match.
HTH
Ben Hartley