-
FREE MEMBER
NO Posting or PM's Allowed
Can you I.D. the parts in this Kyber Pass special?
This pic has been handed around the web, so I don't know the origin.
This could be in Afghanistan.
You can tell most of it is AK, but the safety looks like an Enfield or P-14 part.
The rest, I don't know.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
10-23-2010 02:21 PM
# ADS
Friends and Sponsors
-
Legacy Member
The whole action looks P14, the bolt looks cut down and rewelded to make it straight. Its hard to tell from the photo.
-
The Following 2 Members Say Thank You to Brit plumber For This Useful Post:
-
-
Legacy Member
I wouldn't want to comment on what it is but I certainly would like to own it. That rifle is a masterpiece. This just goes to show what a bit of thought and a bin of trash parts can produce. A good minds eye, helps as well. I want one.
-
-
Advisory Panel
I want to know where his trash bin is!
This is one I would really like to sit down with for a while, just to check it over completely. It would be interesting to know what else might be on it! Can't say from the photo, but that might even be a P-14 rear sight.
Politicians who attempt to forbid people from owning anything that can be made into a firearm obviously have never taken close look at a Webley or Enfield revolver: most of one is made out of 2 pieces of flat plate and an inch or so of round stock.
.
-
-
Legacy Member
I would like to know if the gas port is plugged..... before I pulled the trigger.
-
-
FREE MEMBER
NO Posting or PM's Allowed
I've never seen anything like that.You have to be very brave to pull the trigger