-
Robot RSS News Feeds Scrounger
Converting a 1915 Stevens Favorite
Turning a wallhanger into a shooter is a project every gunsmith ought to try at least once. Here's what one 'smith did to a .32 Long Stevens rifle.
More...
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
01-05-2011 02:00 PM
# ADS
Friends and Sponsors
-
Legacy Member
Nice write up. I'm planning on doing the same thing to a Hopkins and Allen boys shotgun in .38xl. In its current chambering it will chamber a .357 round.
john
-
-
-
Legacy Member
Remington Rolling Block conversion to 22 rim fire
Attachment 18892Attachment 18891Attachment 18893Attachment 18894My Father bought this 43 cal Remington from Hunters Lodge, it was in NRA horrible condition, it sat in his basement for another 30 years. The wood was gone, I cut the barrel at ten inches than bored the inside out to .50 inch. I bought a 3/4 inch round 22 rf barrel blank and turned down the last ten inches to fit inside the original barrel, also made a hard steel plug for the end of the chamber. I made the scope blocks for the barrel and converted the breech to rim fire nd made the extractor. I never liked the rolling block trigger so I made a new trigger with a sear and bent the lower tang for a pistol grip. I sent out the receiver for a case color and made the stock and fore-end from Calif walnut. I could still convert the breech back to center fire but it is quite accurate in 22rf.
-
Thank You to RCS For This Useful Post: