7.62mm factory magazines - The L8 and L42 connection (by Peter Laidler)

[Badger]

With thanks to Advisory Panel member Peter Laidler, a new article has been added to the Technical Articles for Milsurp Collectors and Re-loaders (click here).

7.62mm factory magazines - The L8 and L42 connection (by Peter Laidler) (click here)

Article Extract .....

Someone asked a good question some weeks ago about these magazines and of the feed problems that you can encounter, even with a machined body as on the L42’s. I was going to say L8’s too but………… Let’s start with the L8’s shall we? …... article continues in link shown above .....

(Click PIC to Enlarge)

Peter has added a personal request in regards to this article.

Note: If you have any questions or don’t understand something or my instructions are ambiguous then please ask on the forum and NOT by PM (Private Message). That way everyone will get the benefit of the question and answer.

Regards,
Doug

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.