-
Legacy Member
Enfield No 4 buttstock question?
Purchased what appears to be a NOS No 4 buttstock in hopes of restoring a sporteized piece.
Markings at the lower wrist N22 and ->.The questions I have is the stock appears to have some sanding marks would these be original and should I attempt to sand them out with light with the grain sanding? Meaning of the N22 mark?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-27-2012 08:12 PM
# ADS
Friends and Sponsors
-
Contributing Member
Had a similar issue with my recent purchase of a No 4. I was told they are not supposed to be sanded cross grain so removing them would be best.
I have books on order which will hopefully help with the markings but I won't know that until they arrive and I'm not sure when that will be. Hopefully soon as I'm not the most patient person waiting for books.
-
-
-
Legacy Member
I actually have 2. The one in the photos and a pretty nice used Savage which would probably be more approaite as the No 4 in question is a Savage. It may be for naught as my search for a barrel to replace the bobber has gone nowhere.The photo below is the patient in question. Perhaps add No 5 wood and flashider for a No5 clone if I cannot find a barrel? I even concidered shortening the forestock and making a full stocked No 4 carbine (I may get called names for either). From a financial standpoind it seems to be a loosing proposition but I'm not in it to make money. Not in it to loose too much though.
-
-
I'd leave the stock "as is". When they were plentiful that's how they usually looked. My few remaining NOS Canadian stocks tend to run a bit "fat". The British ones were more nearly on size.
-
-
Advisory Panel
Originally Posted by
HOOKED ON HISTORY
Meaning of the N22 mark?
Component contractor's code for Curtis & Sons.
N = Northern District
-
The Following 2 Members Say Thank You to Patrick Chadwick For This Useful Post: