+ Reply to Thread
Results 1 to 9 of 9

Thread: Fazakerly No 8 MK I question

Click here to increase the font size Click here to reduce the font size
  1. #1
    Legacy Member Frederick303's Avatar
    Join Date
    Aug 2008
    Last On
    07-28-2020 @ 09:41 PM
    Location
    Pipersville PA US
    Posts
    739
    Local Date
    04-24-2024
    Local Time
    09:11 PM

    Fazakerly No 8 MK I question

    Gents,

    I have a chance to buy a Fazakerly 1951 No 8MK I. The rifle is used with what appears to be a very nice bore and crown. The only real defect is the buttplate which was so deteriorated that it was replaced with a non military type, with no alteration the the buttstock. It of course has some wear on the suncorite so the park is showing on places on the barrel and the action body.

    Here is the kicker, I guy is a fellow rifle competitor and so I am compelled to make sure he gets the full worth. He asked me how much it was worth and I told him I thought he would get about 800 dollars for it on gunbroker. He then offered it to me for that sum or whatever I though I would be willing to pay. I was thinking more like 750 straight up.

    So does anyone here have a clue as to how much one of these rifles would go for on gunbroker? Is 750~800 fair? I have never seen a Fazakerly No 8, only the NZicon contract No 8 rifles here in the US of A. On the other hand I have a BSA NZ No 8MKI I bought on Gunbroker ~6 years ago but it only cost me 350, ~410 after dealer charges shipping and transfer so perhaps the goign price is less. I am inclined tell him that he should put it on Gunbroker with no reserves and he will find the real price. He seems a little scared of this, but it seems to me if the rifle is uncommon that is the best way for him to get the real price. Does anyone heree have a feel for what he might expect to get for one of these?


    Any insights will be of aid.
    Information
    Warning: This is a relatively older thread
    This discussion is older than 360 days. Some information contained in it may no longer be current.

  2. # ADS
    Friends and Sponsors
    Join Date
    October 2006
    Location
    Milsurps.Com
    Posts
    All Threads
    A Collector's View - The SMLE Short Magazine Lee Enfield 1903-1989. It is 300 8.5x11 inch pages with 1,000+ photo’s, most in color, and each book is serial-numbered.  Covering the SMLE from 1903 to the end of production in India in 1989 it looks at how each model differs and manufacturer differences from a collecting point of view along with the major accessories that could be attached to the rifle. For the record this is not a moneymaker, I hope just to break even, eventually, at $80/book plus shipping.  In the USA shipping is $5.00 for media mail.  I will accept PayPal, Zelle, MO and good old checks (and cash if you want to stop by for a tour!).  CLICK BANNER to send me a PM for International pricing and shipping. Manufacturer of various vintage rifle scopes for the 1903 such as our M73G4 (reproduction of the Weaver 330C) and Malcolm 8X Gen II (Unertl reproduction). Several of our scopes are used in the CMP Vintage Sniper competition on top of 1903 rifles. Brian Dick ... BDL Ltd. - Specializing in British and Commonwealth weapons Specializing in premium ammunition and reloading components. Your source for the finest in High Power Competition Gear. Here at T-bones Shipwrighting we specialise in vintage service rifle: re-barrelling, bedding, repairs, modifications and accurizing. We also provide importation services for firearms, parts and weapons, for both private or commercial businesses.
     

  3. #2
    Contributing Member Brian B's Avatar
    Join Date
    Oct 2007
    Last On
    Today @ 06:19 AM
    Location
    ALTADENA, CA
    Posts
    360
    Real Name
    Brian Brown
    Local Date
    04-24-2024
    Local Time
    06:11 PM
    There is one for sale now with 5 days to go and it is at almost $450. It has a mismatched forend. I picked up one last year through a private party for $425 which I thought was a good deal. I think $600 would be a fair price.

    Just my two cents.

    Good luck,

    Brian

  4. Thank You to Brian B For This Useful Post:


  5. Avoid Ads - Become a Contributing Member - Click HERE
  6. #3
    Advisory Panel Patrick Chadwick's Avatar
    Join Date
    Sep 2008
    Last On
    06-25-2023 @ 06:36 AM
    Location
    Germany
    Posts
    5,032
    Local Date
    04-25-2024
    Local Time
    03:11 AM
    I bought 2 for less than you are being asked for 1. OK, it was euros and I am very, very patient when I am looking for something special.

    I have collected a lot of Egun sales results for No. 8s, over years, especially where the number of the rifle could be read off the receiver, and I have a very good idea of what is achievable over here. The answer is 400 (grab it and run) to 600 (look at it very, very carefully) euros. The price you mention is, literally "top dollar", and for that I would expect the rifle to be well-nigh perfect for shooting and collecting.

    My first No. 8 was correct, but with a No. 4 butt. Peter Laidlericon wrote a couple of years ago that that's OK, they were sometimes set up like that to increase the "No. 4 feeling". It shoots better than some modern match rifles, and targets have been posted on the forum to demnostrate the fact.

    The other had been "sporterized". Yeuch, yeuch, yeuch! I cleaned out EFD to get it back into original configuration. You are going to have to be extraordinarily lucky to find the proper butt pad.

    Both rifles produce first-class performance. Do not even consider the price you mentioned unless it will put ten shots in one ragged hole at 50 yards. Mine do that. A normal life will not wear out a 22 bore shooting lead bullets, so the only real risk it that it has been neglected or the crown has been dinged. And forget the tatty suncorite. Strip it off and you will probably find perfectly serviceable parkerizing underneath.

    But the No. 8 is the best trainer ever. They are sought after, so be prepared for a bit of pain in the wallet.
    Last edited by Patrick Chadwick; 02-01-2013 at 12:21 PM.

  7. #4
    Contributing Member Brian B's Avatar
    Join Date
    Oct 2007
    Last On
    Today @ 06:19 AM
    Location
    ALTADENA, CA
    Posts
    360
    Real Name
    Brian Brown
    Local Date
    04-24-2024
    Local Time
    06:11 PM
    Brian Dickicon used to carry repro butt plates and floor plates. Very nice quality repros.

    Brian B

  8. #5
    Legacy Member Frederick303's Avatar
    Join Date
    Aug 2008
    Last On
    07-28-2020 @ 09:41 PM
    Location
    Pipersville PA US
    Posts
    739
    Local Date
    04-24-2024
    Local Time
    09:11 PM
    Thread Starter
    I bought a few for my Enforcer clone and my BSA No 8 which aslo had a worn out buttplate.

  9. #6
    Contributing Member Brian B's Avatar
    Join Date
    Oct 2007
    Last On
    Today @ 06:19 AM
    Location
    ALTADENA, CA
    Posts
    360
    Real Name
    Brian Brown
    Local Date
    04-24-2024
    Local Time
    06:11 PM
    Looks like my estimate was low!!

    Britishicon Lee Enfield BSA No.8 MK1 .22 cal Trainer : Curios & Relics at GunBroker.com


    Brian B

  10. #7
    Legacy Member 5thBatt's Avatar
    Join Date
    Dec 2007
    Last On
    04-21-2024 @ 11:20 PM
    Location
    Zombie Town, now with a H
    Posts
    774
    Local Date
    04-25-2024
    Local Time
    01:11 PM
    One just closed on NZ's TradeMe, had an opening price with no reserve of NZ$650 & no bids.
    But of course thats New Zealandicon, not the the US

  11. #8
    Advisory Panel
    Warren's Avatar
    Join Date
    Dec 2006
    Last On
    04-20-2024 @ 01:51 PM
    Posts
    1,193
    Local Date
    04-24-2024
    Local Time
    09:11 PM
    Most if not all No.8 butt plates will turn to caca over time.
    You can get a hard resin replacement at Vintage Grips in FL or I believe Brian Dickicon also has/had some.
    The repro's are a good copy and worth the money. If you store your No.8 rifles vertical on the butt plate most will break up over time

  12. #9
    Legacy Member 5thBatt's Avatar
    Join Date
    Dec 2007
    Last On
    04-21-2024 @ 11:20 PM
    Location
    Zombie Town, now with a H
    Posts
    774
    Local Date
    04-25-2024
    Local Time
    01:11 PM
    Quote Originally Posted by Warren View Post
    Most if not all No.8 butt plates will turn to caca over time.
    You can get a hard resin replacement at Vintage Grips in FL or I believe Brian Dickicon also has/had some.
    The repro's are a good copy and worth the money. If you store your No.8 rifles vertical on the butt plate most will break up over time
    Good point Warren, i store my No8s & No5s muzzle down for that reason.

+ Reply to Thread

Similar Threads

  1. 1957 Fazakerly Mk.2?
    By Surpmil in forum The Lee Enfield Knowledge Library Collectors Forum
    Replies: 9
    Last Post: 11-12-2011, 10:53 AM
  2. New, (to me), No4 Mk2 Fazakerly 1954
    By chainshot09 in forum The Lee Enfield Knowledge Library Collectors Forum
    Replies: 4
    Last Post: 10-03-2011, 01:29 PM
  3. Question about a question mark
    By Demo in forum The Lee Enfield Knowledge Library Collectors Forum
    Replies: 5
    Last Post: 07-12-2011, 05:11 PM
  4. Fazakerly Mk1 sight on a BSA T?
    By 218bee in forum The Lee Enfield Knowledge Library Collectors Forum
    Replies: 3
    Last Post: 09-11-2009, 07:46 PM
  5. Bad Morning at Fazakerly in early 1953
    By Lance in forum The Lee Enfield Knowledge Library Collectors Forum
    Replies: 2
    Last Post: 06-09-2009, 09:24 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts