-
FREE MEMBER
NO Posting or PM's Allowed
Draws on a no4, wood choices.
I have a small piece of maple, which I think gets used for wooden mallets? and a piece of ash, both seem rock hard. Which woud be the choice for new draws?
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
08-22-2013 07:45 PM
# ADS
Friends and Sponsors
-
Well don't use maple for a start. Now that I think of it, don't use ANY oily wood............. Maple being the worst offender
Last edited by Peter Laidler; 08-23-2013 at 04:29 AM.
-
Thank You to Peter Laidler For This Useful Post:
-
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks, bummer....I dont know too much about wood......research time...!!
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
I have to go see what I can get...."fancy" wood is hard to get these days by us plebs...I might be able to pick up a bit on Trademe.....(NZ
's ebay)
r
-
Advisory Panel
If all you want to do is repair the draws on an Enfield, then why not go to a gunsmith (a real hands-on smith, not a dealer) and buy an old broken-off stock. Shotguns, for instance, are usually weak around the locks, and when they break it is often not worthwhile to repair them. A real gunsmith will probably have several broken stocks kicking around, and for the price of a beer (or two) you will get a chunk of really mature, stable walnut that will enable you to fit up a battalion of draws!
-
-
Originally Posted by
ssj
I have to go see what I can get...."fancy" wood is hard to get these days by us plebs...I might be able to pick up a bit on Trademe.....(
NZ's ebay)
Might I suggest calling one or some local joiners and asking them nicely if you could get some small offcuts for your project. I can't think of any that I have worked for or know that would not help you for nothing in this. Chances are that you could pick their brains for tips and timber selection too. Most joinery people will have a genuine interest in what you are trying to do, and a couple of scaps from the pile nothing to them. The advise they might offer could be the most valuable thing you walk away with.
Good luck!
-
Thank You to tbonesmith For This Useful Post:
-
While you're there Tbone, remember the wooden sailing dinghy that you were in the process of making for your daughter. Did you finish it? Can we see some pictures of the finished article. Fraternal salutations from St Edmunds 6451
-
-
Not quite, but it so close. I will update that thread this weekend ... And pull my finger out and knock it over...
-
Register To Reply
