-
FREE MEMBER
NO Posting or PM's Allowed
SMLE barrel clearance at nose cap
Recently I was looking over a BSA manufactured SMLE that had been re-barrelled and noticed that the barrel was in contact with the nose cap (12 o'clock position).
I presume there should be even clearance all round the barrel where it exits the nose cap. If this is a problem are there any areas to check to restore the correct clearance?
Regards....
...Titan
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
02-21-2014 07:47 PM
# ADS
Friends and Sponsors
-
Advisory Panel
This was covered in detail a short while ago. See Nose Cap Fitting Question
-
Thank You to Parashooter For This Useful Post:
-
-
FREE MEMBER
NO Posting or PM's Allowed
Parashooter
Thank you....
...Titan