-
Legacy Member
6.64 million serial range Inland , made w bayo lug?
Would an Inland carbine in the 6.64 million serial range and a 12-44 barrel date have been built with a bayonet lug?
Len
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
05-31-2015 11:30 AM
# ADS
Friends and Sponsors
-
Legacy Member
More than likely, yes. Barrels usually pre-date built on date by a month or more. I think around 6.3 Million is where the Type III band was started. Should have one of these: AI, H.I., JI, KI, SI
-
Thank You to imarangemaster For This Useful Post:
-
-
Legacy Member
-
-
Legacy Member
I agree. I own a M1A1 Original Inland 6422xxx with Inland 12-44 barrel and type 3 AI band. John
NRA LIFE, ECFNRA, Carbine Club, C.C.A.,NYSRPA, AOH JFK Div.1, American Legion
-
The Following 3 Members Say Thank You to JOHN42768 For This Useful Post:
-
Legacy Member
Inland started to use the type 3 band in November 1944 in the 6.3 million range. The M1A1 carbines were the first to receive them and any left over went to the normal production. This increased each month as production of the type 3 bands increased. It wasn't long before all production had the type 3 band. By the time the type 3 band came into use the barrel and receiver production was on an even footing and most receivers got barrels dated the same month they were made.
-
The Following 7 Members Say Thank You to Bruce McAskill For This Useful Post: