Swedish Mauser Front Sight Removal and Installation

[rge0012]

My swedish mauser M38 shoots nice 2 inch groups at 100 yds; the only problem is that they are about 15 inches above the aim point. The current front sight is stamped "-0.5," and I'd like to install a taller front sight. I've never attempted to remove or install a front sight...any instructions, tips or recommendations would be very much appreciated. Thanks!

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

A simple drift and tap it out. I'd grab the front end in a padded vise and then there's no play. Just use a big enough hammer and drift to do it. Most use too small both and end up marring.

[oldfoneguy]

Try and mark the sight base with the center point of the current front sight.
Use a marker or tape to help get the windage in the ball park.
Much less frustrating than guessing it and being a foot off to start with. - Bill

[rge0012]

I swapped out the sight, and it's now shooting point of aim at 100 yds. Thanks for your advice!

Greg