-
FREE MEMBER
NO Posting or PM's Allowed
AIA M10 B2 Rail
Hello,, im looking to install a scope on my AIA M10 B2 rifle,, there is no rail attached,, could anyone comment on as to what picatinny rail could be used for mounting
tks
Fred Nl
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
11-17-2016 02:50 AM
# ADS
Friends and Sponsors
-
Hi ... 
You might want to try the Google CSE custom search engine located in the top right corner where it says "Search Milsurps.Com"
For example, in your case, type in the words aia m10 or aia and see what happens .. 
I only had a quick look, so I'm not sure what the exact content is about, however, it turned up many past threads. Perhaps there's information contained there that may be helpful.
Regards,
Doug
-
-
-
Advisory Panel
Contact the manufacturer, if you can. Drilled & tapped already?
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same. 
-
-
Legacy Member
Originally Posted by
Surpmil
Contact the manufacturer, if you can. Drilled & tapped already?
Problem is no one has heard anything from or about AIA for many many moons as far as I know. I have the email address of one of the top guys and haven't had a reply to questions in a couple of years. Unfortunate as I have 3 different and all are good guns and all of mine came with a rail.
I bet you are going to have to measure and then hope someone knowledgeable can help you or get a blank rail and have it drilled to match.
Why use a 50 pound bomb when a 500 pound bomb will do?
-
-
Legacy Member
Hi....when I purchased mine it came with rail installed. I purchased it 2nd hand but sure the B2 came drilled and tapped with a rail as an factory accessory along with a cheek piece that was optional too install. Inspite of all the rhetoric, |I'm very satisfied with mine. I'm a machinist by trade and I can attest it's a very well put together piece. I'm sure the metallurgy and heat treating etc was as good as factory wartime or better inspite of all the naysayers. When I'm squeezing the trigger and totally concentrated on the sights and distant target there is not a thought that crosses my mind that the bolt may break free of the action and puncture my forehead!!!!!!!!!!!!!!!
Cheers to the AIAM10B2 MATCH RIFLE.
Originally Posted by
Fakelly
Hello,, im looking to install a scope on my AIA M10 B2 rifle,, there is no rail attached,, could anyone comment on as to what picatinny rail could be used for mounting
tks
Fred Nl
-
Register To Reply
