US Made Parts

[McGoonagall]

Is there anyone out there making US parts for the BREN? I haven't found anything.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

I think most are kits from cut guns. There should be lots out there though.

[Brit plumber]

I've seen those 922r (or whatever the numbers are) compliance parts for sale, pistons are a coomon compliance part.

[McGoonagall]

Sorry I should have been more clear. It's the 922r parts that I'm looking for.

[MG34bar]

Lynden of Kiwi Custom Guns (located in California) makes (or at least made) many of the new US small parts for the semi-auto Bren. Don't know if he is still working on Brens or has moved on to other projects. I wrote to him about buying a spare "striker" about 6 months ago, but he replied that he had none and wasn't going to be making any in the near future. You should be able to locate him on the "error net".

Joe

[ActionYobbo]

the metal parts are usually done in small runs. keep you eye on the builder forums and when they come up get them while you can. The wood parts seem to be the same way but with blue monster closing they will be harder to find.
If you cut and weld the parts that come with the kit yourself then you only need to find a striker and firing pin to make it work then to get your parts count up you can change the trigger or wood or gas piston or mag followers and floor plates

[tr63]

Good to know .